JL / JT Door Hinge Mount for RotopaX packs (Mount ONLY)

$149.99

RDE-J003

Description


This product is produced by Red Dot Engineering and is NOT a RotopaX branded product.

Use this mounting Kit to adapt ONE RotopaX branded “Pax Mount” to hold a RotopaX branded container on any driver or passenger door of a JK, JKU, JL JL and JT Jeep Wrangler and Gladiator. *Kit can be added to front or rear doors on a 2007-2017 JK and 2018 and newer JL and Jeep JT . Pax Mount and RotopaX Container sold separately.

See images for examples of mounting locations. Up to four mounts per vehicle.

Pax Mount and RotopaX Container sold separately.


Warning: If using this mount with containers on the rear passenger doors, care must be taken when opening and/or closing the front doors with the rear passenger doors in the full open position.

Installation Instructions:

Step 1: With Door in the full closed position, remove the two factory bolts holding the top hinge to the door. (Retain factory bolts)

Step 2: Place one “Roto Base hinge mount” over factory hinge plate. Replace and tighten the factory both bolts to factory specs. (See image #1)

Step 3: Repeat step 1 & 2 with lower hinge.

Step 4: Attach the “Pax” mount (Sold Separately) to the Roto Mount Plate with the 2 supplied 5/16” x 3/4” bolts and 2 5/16” flat washers. *(DO NOT use the bolts supplied with the “Pax” mount.)

Step 5: Fasten the Roto Mount Plate to the two Roto Base hinge mounts using the 4 supplied 5/16“ x 1/2” bolts and 4 of the 5/16” flat washers. (See image #2)

Step 6: Mount Storage containers as instructed by manufacturer.

Additional information

Weight 1 lbs
Dimensions 15 × 8 × 1 in